If there are no broken pins, the unit is faulty. Password — The password used to log in to the FTP server. This value should be greater than the expected round-trip time. The page is not updated automatically. Click Rel oad to display the latest information. Apply — Opens a confirmation dialog box, where all configurations can be confirmed and applied. Display of performance data is enabled on the VC-4 Configuration page, see Section 2.
| Uploader: | Kazracage |
| Date Added: | 4 August 2014 |
| File Size: | 21.76 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 91331 |
| Price: | Free* [*Free Regsitration Required] |
Line Length —— Choose line length,or feet. Automatic Downgrade — Automatically performs sof tware downgrade of units with newer software revision than the one specified by the baseline. The list of actions on the left side of the page shows the current configuration flow. Apply — Applies all changes wit hout leaving the page. This value must be larger than Error Threshold Low. The port number can be miniink to any integer value between 2 and The parameter can only be changed when an USB-cable connection is established.
Only available if a software up grade is in progress.
(PDF) MINI-LINK-Craft-User-Interface-Descriptions | Roy Butcher -
Clicking the link o pens the Control Protection page, see Section 2. If any boards have been inserted prior to the Telecom Standard change, remove all boards execpt the NPU, make clear reservations on minilnk empty miinlink, change standard, make sure that the correct Telecom Standard is visible in the NE Alarms and Status page, insert boards again, and continue with configurations.
Holdoff Time —— Used to filter out short disturbances on synchronization input signal. Display of performance data is enabled on the VC-4 Configuration page, see Section 2. The E1 in bold typeface is the one for which the page is opened.
Only available if the SMU2 is crft for prote ction. Clicking a link ope ns the E1 Alarms and Status page, where a complete alarm description can be foun d, see Section 2.
Clicking the link in a column header sorts the list accordi ng to the items in that column and removes the link in the header. Bit 2, if set, indicates that the router can forward IP multicast datagrams between Autonomous Systems called inter-AS multicast routing. This value should be greater than the expected round-trip time. PLM — Payload Mismatch. If you have installed licenses for features that cannot be used in the current hardware configuration, those features will also be shown in the list.
Ericsson Mini Link Craft 22 Download
Only available if the SMU is configured for co-siting using this traffic rate. Destination — The destination IP address of this route. Higher Layer indicates the worst severity of the alarms on higher la yer interfaces. Tra ffic Descriptor —— The name of the involved traffic descriptor. C licking a link opens the MSP Alarms and Status page, where a complete alarm desc ription can be found, see Section 2.
Advanced Uninstaller PRO
Click Reload to display the latest information. Delete — Deletes the selected VC Cross-connections. Product Numbe r — The product number of the baseline. When a whitelist is selected, only traffic from addresses in the whitelist are allowed; other traffic will be discarded.
The values are read-only.
Even t Time — The time when the entry occurred. Only available when status is Upload Failed minilimk Download Failed. A blank row or column indicates that the interface is protected with an interface not visible on the page.
Figure The VC Performance 15 minute Intervals Page The duration of an invalid interval is not known, therefore the Date and Time parameters cannot be displayed for intervals following an invalid interval.
The unit with the currently active line is the one carrying traffic.
No comments:
Post a Comment